Installation - Install takes approx. 2hrs with basic hand tools done on the ground of your driveway or garage. Quicker if you have automotive style lift. Cutting may be be required to fit shorter wheelbase bed/cab configurations. Clamps, hangers and hardware are included. You may have to re-use some factory hardware.
Fuel Mileage - Expect to see a significant increase in fuel mileage. If your DPF is plugged up your probably averaging about 13-14 mpg. More or less depending on the severity of the restriction. After deleting the DPF/CAT expect to get a combined mileage of 18-19 mpg. Larger tires and poor driving habits will skew mileage downward.
Tuner Required- Removal of the DPF, CAT, SCR, and/or DOC involves removing and eliminating emission related sensors. A DPF delete capable tuner is required to prevent any check engine light or diagnostic trouble codes from setting.
EXHAUST SYSTEM DESCRIPTIONS BELOW.
Stay at the top on race day with the P1 Race Parts 4″ & 5" PLM Series Race Exhaust System. P1 Race Parts PLM Series Race Exhaust System is built from Aluminized Steel and comes complete with OE style hangers and clamps for an easy installation.
Features:
We make our exhaust systems stronger where they need to be the strongest with machined turbo flanges. Most
of our modern Dodge systems come with a machined flange that matches perfectly to your stock or aftermarket turbo. The alternative construction of a turbo flange is to over expand the pipe and flare it out. We used to do that, but that process created a weak spot in the 16ga steel and often had to replace downpipes for damages caused by stress and vibrations off the turbo. If you order a FLO~PRO kit, your turbo clamp will thank you! |
|
Why would you buy a system that only has 1" of weld holding the hangers on? Your truck works as hard as you do and hangers take a beating. We machine all our exhaust hangers to contour to the shape of the pipe. This allows us to apply a longer bead of weld to the hanger to greatly reduce hanger failure. Where there was once one inch (1") of weld before, now we have 6-7" of weld on our hangers. Using alternative hanger clamps causes unnecessary stress and added time to installing your kit. The clamps don't typically have a whole lot of surface area to weld, so we try and avoid using them as much as possible. |
|
All Rights Reserved | Explosive Diesels
FAST AIR SHIPPING AVAILABLE
1 YEAR WARRANTY ON ALL TUNING AND SOFTWARE
GUARANTEED SAFE PAYMENTS